Supports and Shelves for Decoders
Filter
Sort by:
Decoder mounts and shelves: the problem arises after wall-mounting the TV
Once you mount your television on the wall, the cabinet below is no longer needed, leaving decoders, players, consoles, and routers out of place. That is where the two solutions in this section come in: the dedicated bracket, which holds the device behind or below the television and keeps it out of sight, and the tempered glass shelf, which creates a wall-mounted support surface where there is no cabinet. Both also solve the second problem: dangling cables.
Selection table
| What you need to organize | Solution |
|---|---|
| Sky Q decoder, hidden and out of sight | Dedicated wall-mount bracket for Sky Q |
| Sky Q Mini in a second room | Dedicated bracket for the Mini module |
| Generic decoder or Blu-ray player, up to 3 kg | Universal folding wall bracket |
| Multiple devices below the TV, no furniture | Universal wall-mounted AV shelf |
| Large support surface, 560x210 mm | Tempered glass shelf for AV devices |
| Shelf for pre-installed cable management column | Matching 380x280 mm glass shelf |
The real constraint is ventilation
Decoders, receivers, and consoles generate heat and are designed to draw air through vents—almost always located on the bottom or sides. Putting them into a closed niche or placing them directly against the wall causes them to operate at higher temperatures, and heat is the leading cause of failure for these devices. A bracket or shelf keeps the device elevated and free on multiple sides: this is a practical advantage, not just an aesthetic one.
However, be careful with infrared receivers: if the decoder ends up completely behind the television, the remote control will stop working. In that case, you need an IR extender, or you must choose a side position that keeps the sensor in view.
Expert advice. Glass shelves have a specific weight capacity and contact points: the load must be distributed, not concentrated on the front edge. A heavy amplifier placed on the edge exerts the worst possible leverage. Regarding installation, glass does not forgive leveling errors: if the two supports are not perfectly level and at the same height, the shelf will be under torsional stress. Mark the holes with a spirit level, not by eye, and use anchors suitable for your wall—for drywall, use expansion or toggle bolts.
Frequently asked questions
Is the Sky Q bracket also suitable for the Sky Stream decoder?
No, dedicated brackets are shaped to the dimensions of a specific model. For devices other than the Sky Q, use the universal folding bracket, which adapts to any decoder within the stated weight capacity.
What is the maximum weight of a decoder I can hang?
The universal folding bracket in this section is rated for up to 3 kg, which covers decoders, Blu-ray players, and mini PCs. For heavier devices—amplifiers, receivers—you need a shelf, not a bracket.
Are the glass shelves safe?
Yes: it is tempered glass, which has a much higher resistance than standard glass and, in the event of breakage, shatters into non-sharp granules. The condition is to respect the weight capacity and mount it level on both supports.
How do I hide the remaining visible cables?
Use a modular wall-mounted cable management column, which gathers power, HDMI, and antenna cables into a single profile and matches the glass shelves. You can find it in TV accessories.
See also wall TV mounts, HDMI cables, and audio-video distribution.
